Model 2120 Tractor TM-4252 (Dec-70) Hydraulic System 70 Selective Control Valves (Spool Type) 25-5 L 51557 Fig. 4 Exploded View of a Dual Selective Control Valve 1 Valve housing and spool assembly (closed on one side) 11 V-packings 12 Washers 13 Racks 14 Pins 1 5 End plate 17 Knob 18 Seal ring (Teflon) (2 used) 22 Locking ball 23 Locking spring 24 Stop screw 25 O-ring 26 Seal rings (8 used) 27 Cap screw (2 used) 19 Pin 20 Hex.
socket screw each valve) 32 Valve housing and spool assembly (open on both sides) 34 Control lever 36 Cap screw (2 used) 37 Pinion shaft 39 Washer 40 Cap screw 41 Two dual selective control valves 28 Lock washer (2 used on INSPECTION Check end plate 15 or 33, racks 13 and pinion shafts 37 for serviceability. Replace parts, if necessary. Check valve spool and housing for scores or other damage. If necessary, always replace spool and valve housing as one set. Since they are lapped in, they are available only as a matched set. ASSEMBLY Discard V-packings 11 (figs. 2 to 4), seal rings 18 and 26 as well as all O-rings.
Assemble by reversing sequence of steps explained under "Disassembly", as shown in figs. 2, 3 or 4. Check resilience of spring 3 and locking spring 23 (see Specifications). Take care not to mix up valve spools or housings if more than one valve has been disassembled. Printed in Germany