80 Miscellaneous 5-4 Belt Pulley Model 2120 Tractor TM-4252 (Dec-70) REPAIR Install bearing cone 30 onto drive shaft. Install new oil seal 20 in case, metal side out. Wash all parts in a clean solvent and dry, using compressed air, before inspecting for serviceability. As a temporary measure, install a pack of shims 9 of specified thickness (see Specifications) and bearing cone 8 on bearing pin 10. Place drive gear hub assembly on inner bearing cone 8 in belt pulley case. If it is necessary to replace the inner bearing pin 10, be sure to install the new pin with small bore facing inward (see fig. 2). Fig. 6 Removing Bearing Cup from Drive Gear Hub Fig.
7 Measuring for Shim Requirement a Feeler gauge 15 Cap Screws 7 Bearing cup Position quill 16 on belt pulley case, and install two cap screws 15 as shown in fig. 7 finger tight on opposite sides of the quill. Use a feeler gauge to measure clearance between case and quill to determine shim pack required. Install shim pack to the measurement determined above, and secure quill to belt pulley case with cap screws 15. If the cup must be replaced, use a puller as shown in fig. 6 to remove the old cup, and press a new cup into place. If the gear 5 (fig. 5) of hub 4 must be replaced, use a press to remove the old gear.
Press a new gear into place, making sure that the Woodruff key is in place and that the new gear is pressed fully onto the hub shoulder. NOTE: Shim pack is temporary until correct gear backlash and hub assembly end play is adjusted. ASSEMBLY AND ADJUSTMENT NOTE: For location of parts in assembly refer to fig. 5. Insert drive shaft 24 with bearing cone 27 into the belt pulley case (see fig. 4). Printed in Germany