ou Miscellaneous 20-2 Hydraulic Trailer Hitch Model 2120 Tractor TM-4252 (Dec-70) GENERAL INFORMATION Remove towing hitch. The raising and lowering of the towing hitch, with its anti-twist device, is made by operating the rockshaft control lever. To lower the towing hitch, also pull up on release rod (see Operator's Manual). The assembly is made up of simple parts which require very little maintenance, apart from regular greasing. If necessary, all parts can easily be taken apart or replaced after having removed securing bolts, nuts or cotter pins.
The towing hitch is secured sideways by lifting plates bolted to the transmission case and underneath the transmission case by means of a support bracket. Check all parts for cracks, wear, damage or distortion and replace, if necessary. REPAIR Remove cotter pins securing hitch chains to rockshaft lift arms. The assembly and installation of the hydraulic hitch is made by reversing the sequence observed for disassembly and removal. Remove four hex.socket screws 10 (fig. 1) securing the support bracket 12. Also remove the four hex.socket screws 17 which secure the lifting plates 18 and 31 underneath the transmission case.
Screw out four cap screws 34 and both cap screws 35 securing the lifting plates at the right and left-hand side of the transmission case. Lifting plates to transmission case, hex.socket screws ........ 87 ft.lbs. 12 mkg Support bracket to transmission case, hex.socket screws ...... 87 ft.lbs. 12 mkg Bearing support with tow hook to right and left-hand stays, hex.socket screws .................. 55 ft.lbs. 7.7 mkg TORQUES FOR HARDWARE Printed in Germany