John Deere 2120 Tractor — tm4252

20 Engine 15-2 Cylinder Block, Liners, Pistons and Connecting Rods Model 2120 Tractor TM-4252 (Dec-70) Check piston pin bushing and replace, if necessary. NOTE: Always install a new bushing when in¬ stalling a new piston pin. Press in new bushing and ream until the respective piston pin can be inserted by "thumb-press fit". CYLINDER BLOCK I- v 151325 Fig. 1 Checking Top Piston Groove for Wear Remove all gaskets and scrape off any residual deposits. Remove O-rings sealing liners from cylinder block grooves and discard. 1 Piston a Piston can be used again 2 Feeler gauge No. 19.58-90.281 b Discard piston and replace Check piston ring grooves for wear as follows:

Clean piston ring grooves carefully. Using feeler gauge 19.58-90.281 (see 2, fig. 1) check the groove of the top compression ring (trapezoidal-shaped) for excessive wear. As long as there is a gap bet¬ ween the shoulder of the feeler gauge and the piston (see a, fig. 1) the piston can be used again. If shoulder of feeler gauge comes into contact with the piston (see b, fig. 1), wear is excessive and the piston must be replaced. When checking the center piston ring groove, insert a new piston ring. Measure clearance between ring and groove at several points around the ring, using a feeler gauge.

Thoroughly clean the block outside and parti¬ cularly inside with cleaning solvent or by pressure steam cleaning. Make sure all passages and orifices are free from sludge, rust and grease and remove all scale or lime deposits. OIL PASSAGES AND VALVE SEAT BUSHING OF OIL PRESSURE REGULATING VALVE Valve Seat Bushing of Oil Pressure Regulating Valve Using a micrometer, measure all piston diameters at a 90° angle from piston pin. The pistons are cam ground with the largest diameter at right angles to the piston pin (see Specifications). Check piston pins and replace them, if excessively worn (see Specifications). Always use new piston pins when installing new pistons.

CONNECTING RODS AND BEARINGS Replace connecting rod bearings and piston pin bushings at every major engine overhaul. Fig. 2 Driving in Valve Seat Bushing of Oil Pressure Regulating Valve Connecting rods and rod caps are only available as matched sets. Connecting rod bearing insert halves are available in standard sizes and several under- sizes (see Specifications). 1 Valve seat bushing 2 Special tool No. JD 248 3 Special tool (driver) No. 813 Insert bearing insert halves, install rod cap and tighten rod screws to the specified torque. Measure each bearing bore and its respective crankshaft journal at several places.

The difference between the two measurements is the bearing clearance ("see Specifications). Printed in Germany