John Deere 2120 Tractor — tm4252

Model 2120 Tractor TM-4252 (Dec-70) Engine 20 Crankshaft, Main Bearings and Flywheel 20-3 Check teeth for excessive wear and damage. Remove unserviceable gear by means of a commer¬ cial puller. NOTE: Make sure you use the proper undersize bearing. If undersize bearings are too tight and clearance is not within specifications, the journal and bearing will be wiped clean of the oil film, resulting in premature wear. If a press is used for pressing on a new gear, support crankshaft under front throw as shown in fig. 2. Insert new Woodruff key in crankshaft keyway. Press gear on crankshaft so that it is flush against crankshaft shoulder.

To facilitate installation, the gear may be heated to 350° F (180° C). MEASURING CRANKSHAFT END PLAY INSPECTING CRANKSHAFT MAIN BEARINGS If one main bearing half needs replacement, always replace both halves. In such a case check con¬ dition of sliding surfaces and clearance of all crankshaft bearings. Damage in a bearing may be due to excessive wear of another bearing. If an inspection shows that other bearings, though heavily worn, are still within the wearing tolerance, do not hesitate to replace these bearings. All crank¬ shaft bearings should be replaced at every major engine overhaul. If the bearing inserts are to be used again, it will be useful to mark them for proper reinstallation.

Fig. 3 - Measuring Crankshaft End Play with Dial Indicator Remove all bearing inserts from cylinder block and bearing caps. Check all bearings for excessive wear, scores, chipping in which case they have to be replaced. Above all, thoroughly check lateral thrust faces of pilot bearing. Wear of this bearing is also indicated by increased crankshaft end play. X Mounting bar 2 Dial indicator Fasten dial indicator to cylinder block as shown in fig. 3 or in a similar way and position on crank¬ shaft face. Move crankshaft back and forth, using a bar or similar tool and measure amount of clearance on dial gauge (see Specifications). Measure crankshaft bearing clearance:

Bearing clearance is the difference between bearing bore and crankshaft diameter (see Specifications). If the permissible maximum clearance is exceeded, install undersize bearings. CAUTION: Do not apply too much pressure with bar as this could damage new bearing inserts. Printed in Germany