John Deere 2120 Tractor — tm4252

Model 2120 Tractor TM-4252 (Dec-70) Engine 20 Timing Gear Train 25-1 Group 25 TIMING GEAR TRAIN GENERAL INFORMATION The crankshaft gear, camshaft gear and both balancer shaft gears are pressed on and keyed to their respective shafts. The oil pump gear is pressed on its taper seat and secured to the shaft by a retaining nut. The injection pump gear is secured to the pump shaft with three cap screws. The upper and lower idler gears with bronze bushings rotate on stationary shafts pressed into the cylinder block front plate. The camshaft gear, injection pump gear and both balancer shaft gears have timing marks which must be aligned with the center of the crankshaft when No.

1 piston is at "top dead center" of its compres¬ sion stroke. With the other gears no timing is required. DIAGNOSING MALFUNCTIONS See group 5 for diagnosing malfunctions. REMOVAL Fig. 1 Timing Gear Train - Cover Removed L 40463 A Removal of the timing gear cover, the timing gears or the cylinder block front plate does not require removal of the engine. However, split the tractor and remove front end to get access to the front of the engine (see section 10, group 25).

1 Crankshaft gear 2 Upper idler gear 3 Injection pump gear 4 Camshaft drive gear 5 Right-hand balancer shaft gear 6 Lower idler gear 7 Oil pump gear 8 Left-hand balancer shaft gear If engine has to be removed, see section 10, group 25. The helical timing gear train consists of gears 1 to 8 (fig. 1), the gear train being driven by crankshaft gear 1. The upper idler gear 2 drives camshaft gear 4 and injection pump gear 3 while lower idler gear 6 drives oil pump gear 7 and right-hand balancer shaft gear 5. The left-hand balancer shaft gear 8 is driven by oil pump gear 7. Whenever engine has to be overhauled or crank¬ shaft has to be removed, also remove timing gear train as follows: 1.

Remove timing gear cover. Due to the number of teeth of these gears, cam¬ shaft and injection pump shaft rotate at half the crankshaft speed, whereas both balancer shafts run at double the crankshaft speed. 2. Back hex. nut off oil pump shaft and remove cap screws of upper and lower idler gears. Printed in Germany