20 Engine 30-2 Engine Lubrication Model 2120 Tractor TM-4252 (Dec-70) REMOVAL OIL PUMP Remove hex. nut which is secured by three center punch marks. Pull pump gear off the tapered seat on the pump shaft. Drain engine oil and remove oil pan. Place a clean cloth between the teeth of the lower idler gear and the teeth of the oil pump gear. L 48442 Fig. 2 Oil Pump Assembly 1 Pump housing 6 Groove pin 11 Cap screw 2 Shaft for driven gear 7 Gear on pump shaft 12 Spring washers 3 Bearing bushing for pump shaft 8 Hex. nut 13 Pressure pipe 4 Pump drive shaft 9 Pump cover with suction pipe and strainer 14 O-Ring 5 Pump gears 10 Cap screw (3 used) 15 Plug REPAIR RSS NOTE:
For overall and detailed infor¬ mation on repair of the engine lubrication system see Fundamentals of Service, Engines " manual. INSPECTION Pump Housing and Shaft for Driven Gear DISASSEMBLY OF THE OIL PUMP Check pump housing 1 (fig. 2) for distortion or cracks. Especially check sealing surface to which pump cover 9 attaches. Measure diameter of bearing bushing 3. Replace bushing if worn, or if not absolutely perfect. Drive in new bushing with special tools No. JD 253 and 813 so that it is flush with inside face of housing. Pull drive shaft with gear out of pump housing. Remove driven gear from shaft.
Support pump housing by means of a pipe section and press shaft of driven gear out of the housing. Printed in Germany