Model 2120 Tractor TM-4252 (Dec-70) Engine 20 Engine Lubrication 30-5 Adjust oil pressure as follows: Before checking the pressure, warm up engine to allow the lubricating oil to reach normal operating temperature. Check oil pressure by means of special tool 19.58-90.260. Connect pressure gauge instead of oil pressure warning switch to flywheel housing (see fig. 5). At the rated engine speed the gauge should indicate the specified oil pressure (see Tune-Up Data). Operate starter: the oil pressure warning lamp on the instrument panel will now light up. It will only go out when the engine has started and a minimum oil pressure has built up.
To increase oil pressure, place as many shims bet¬ ween plug and spring of oil pressure regulating valve as are required to attain the required pres¬ sure. CAUTION: If the warning light is still on when the engine has run for 10 seconds, stop engine at once and check if shims have been installed between spring and plug of oil pressure regulating valve and CAUTION: However, do not use more than four shims. if the plug has been provided with an aluminium washer. To reduce the oil pressure, remove part or all of the shims located between plug and spring. Turn in plug with aluminium washer and measure pressure. If pressure is still too high, add a second washer.
Bore for the drive shaft in pump housing (with bushing installed) ..................... 0.6315 bis 0.6335 in. 16.040 to 16.091 mm SPECIFICATIONS Diameter of the idler shaft ................... 0.4850 to 0.4856 in. 12.319 to 12.334 mm Dimensions of new parts OIL PUMP Wear tolerance Diameter of drive shaft journal ................. 0.6295 to 0.6305 in. 15.989 to 16.015 mm 0.0030 in. 0.08 mm Radial clearance between gears and pump housing ....... 0.0010 to 0.0040 in. 0.025 to 0.1 mm 0.0005 in. 0.013 mm Gear width .................... ....... 1.4163 to 1.4183 in. 35.974 to 36.025 mm 0.0010 in. 0.025 mm Axial clearance between gears and pump cover ........... 0.001 to 0.006 in.
0.025 to 0.15 mm 0.0050 in. 0.13 mm 0.0020 in. 0.05 mm 0.008 in. 0.2 mm OIL FILTER Screw filter onto fitting by hand until the rubber gasket just touches the cylinder block without compression. Then tighten filter another 1-1/2 turns for proper sealing. Printed in Germany