Model 2120 Tractor TM-4252 (Dec-70) Engine 20 Engine Cooling System 35-3 20 Fig. 3 Water Pump Assembly 3 Gasket 2 Reai cover 3 Gasket 4 Impeller 6 Rubber cap 6 Ceramic washer 7 Special seal ring 8 Adjusting strap 9 Stud 10 Pump shaft with bearing 11 Elbow 12 Pump housing 13 Cap screw (2 used) 14 Cap screw 15 Cap screw 16 Hex. nut 17 Cap screw (2 used) 18 Fan securing plate 19 V*beit pulley 20 Fan belt 21 Fan 22 Cap screw (4 used) 23 Repair set Checking the Water Pump CAUTION: To do this, use special tool No. JD 262 or a suitable tube section that contacts only the bushing-shaped race of the bearing (see fig. 2). If coolant drains from bore "c" during operation (see fig.
1), this generally indicates a faulty seal ring 4 (fig. 1). Check all parts for wear and replace, if necessary. Install special seal 7 (fig. 3) in pump housing, open side facing upward (see fig. 1). Apart from the various spare parts (see fig. 3), a repair set is available (see 23, fig. 3), consisting of ceramic washer 6, special seal ring 7, and pump shaft 10 with bearing. Install ceramic washer in rubber cap so that un¬ polished side of washer provided with a V-groove faces the rubber cap. Make sure that all parts are dry and clean. Check rubber cap 5 and replace, if necessary. Dip rubber cap and ceramic washer in oil and insert in impeller bore (rubber cap should bottom on bore).
The ceramic washer should be flush with the impeller face. Assembly of Water Pump Place pump housing (open side first) on a press and drive bearing assembly with pump shaft into pump housing until bearing face is flush with the hub face. Printed in Germany