John Deere 2120 Tractor — tm4252

Model 2120 Tractor TM-4252 (Dec-70) Engine 20 Speed Control Linkage 40-1 Group 40 SPEED CONTROL LINKAGE GENERAL INFORMATION REMOVAL AND DISASSEMBLY HAND THROTTLE ASSEMBLY The desired speed is selected by means of the hand or foot throttle. The position of these levers con¬ trols through the governor on the injection pump the amount of fuel being injected into the cylinders. Remove right-hand cowl. The hand throttle shaft is self-locking: two spring- loaded friction disks keep the hand lever in the position selected. With engine running at slow idle speed, the stop 4 (fig. 1) of the hand throttle contacts the dash¬ board.

When turning the hand throttle in a clock¬ wise direction to its stop, stop screw 2 contacts the dashboard, and engine speed is increased to maximum rpm. The engine is stopped by means of a shut-off cable. One end of the cable is connected to the injection pump stop lever, the other to a knob in the dash¬ board. CAUTION: Never stop engine by turning off the fuel shut-off valve. Otherwise injection pump will run dry and the internal parts will be damaged. Fig. 1 Removing Hand Throttle Assembly 1 Hand throttle 10 Groove pin 2 Fast idle stop screw 24 Connecting rod 4 Slow idle stop screw 28 Spring pin 5 Groove pins Printed in Germany