John Deere 2120 Tractor — tm4252

Model 2120 Tractor TM-4252 (Dec-70) Engine 20 Speed Control Linkage 40-3 FOOT THROTTLE SHAFT WITH ARM 20 AND SPEED CONTROL ROD 17 (Fig. 2) NOTE: On tractors with foot throttle, the speed control arm 12 (fig. 3) is connected by means of spring pin 26. On tractors without foot throttle, the speed control arm 22 (fig. 2) is attached to the shaft with arm 20 by means of the spring pin 26. Disconnect linkage, remove lever and arm from shaft and withdraw shaft from its two bushings on left-hand side of tractor. SHUT-OFF CABLE Disconnect shut-off cable from injection pump and dashboard. Remove shut-off cable. Fig.

3 Parts of Foot Throttle Assembly REPAIR 1 Foot throttle 2 Cap screw 3 Washer 4 Spacer 5 Rod 6 Jam nut 7 Yoke 8 Headed pin 9 Washer 10 Cotter pin 11 Clevis 12 Speed control arm 13 Return spring 14 Speed control arm 15 Snap ring 26 Spring pin Inspect rods and levers of speed control linkage for cracks or distortion. Check linkage for binding, excessive play or any damage which could result in insufficient engine performance. ASSEMBLY AND INSTALLATION Remove parts of foot throttle as shown in fig. 3. For assembly and installation of speed control linkage, reverse removal procedure as shown in fig. 1 through 3. Printed in Germany