John Deere 2120 Tractor — tm4252

Model 2120 Tractor TM-4252 (Dec-70) Engine 20 Speed Control Linkage 40-5 Make all speed adjustments in the order shown below. 5. Move hand throttle clockwise to the stop (fast idle speed). The engine speed should now be 2650 rpm. If this is not the case, adjust fast idle stop screw 2 (fig. 4) located in stop 12 (fig. 4) of dashboard accordingly. Adjusting Foot Throttle 6. Depress foot throttle until it contacts the foot- rest. Engine speed should now be 2650 rpm. If this is not the case, adjust effective length of foot throttle rod 6 (fig. 4) accordingly. Adjusting Shut-Off Cable Fig. 5 ROTO DIESEL Injection Pump, Installed 7.

Completely push in shut-off knob and make sure there is no gap between shut-off lever of pump and its stop. If shut-off lever is not in contact, disconnect steel cable at injection pump and pull slightly rearward so there will be a gap between the knob and the retainer fastened to the dashboard. 1 Slow idle stop screw 2 Fast idle stop screw 3 Pump throttle lever Push pump shut-off lever by hand against the stop and attach steel cable. To check, run engine until hot. Pull out shut-off knob as far as possible and make sure engine stops quickly. Low idle speed ......... '650 rpm. 1. Disconnect speed control rod at injection pump. Fast idle speed ......... 2650 rpm. 2.

Move pump throttle lever 3 (fig. 5) against pump stop screw 2 for fast idle. SPECIFICATIONS Now engine speed should be 2650 rpm. If this is not the case, adjust pump stop screw 2 for fast idle and lead-seal screw. 3. Move pump throttle lever in slow idle position against the stop screw. Engine speed should now be 650 rpm. If not, adjust pump stop screw 1 for slow idle accordingly. Adjusting Hand Throttle 4. Make sure speed control rod is still disconnected from pump throttle lever. Move speed control lever first clockwise and then counterclockwise to the stop.

Now adjust speed control rod, if necessary, so that it can easily be attached to the pump throttle lever when the latter is in that position where the engine just starts to pick up speed. Then increase effective length of speed control rod by backing off the rear hex. nut two full turns. In this posi¬ tion, tighten front hex. nut and attach speed con¬ trol rod to pump throttle lever. Printed in Germany