Komatsu — 24.9.9 ADJUST ENGINE VALVE LASH CLEARANCE

MAINTENANCE 5 14 mm, Flatblade Screwdriver Locate Top Dead Center (TDC) for Cylinder Number 1 Check and adjust the valves as indicated in the illustration ( I = intake, E = Exhaust). Tighten the lock nut and measure the valve lash again. Torque Value: 24 Nm [18 ft-lb] 6 Mark the pulley/vibration damper and rotate the crankshaft 360 degrees. WARNING To prevent engine or pin damage, be sure timing pin is disengaged. Adjust the valves as indicated in the illustration. Tighten the lock nut and measure the valve lash again. Torque Value: 24 Nm (18 ft-lb) 7 15 mm wrench Install the valve covers and tighten capscrews. Torque Value: 24 Nm (18 ft-lb) 3-67