OPERATION 12.2.3 CHECK OIL LEVEL IN ENGINE OIL PAN, ADD OIL 1. Open the engine side cover at the right rear side of the machine. 2. Remove dipstick (G) and wipe the oil off with a clean cloth. 3. Insert dipstick (G) fully in the guide tube, then take it out again. 4. The oil level should be between the ADD and FULL marks on the dipstick. If the oil is below the ADD mark, add engine oil through oil filler (F). Oil specifications ц SEE "20. USE OF FUEL, COOLANT AND LUBRICANTS ACCORDING TO AMBIENT TEMPERATURE" on page 3-10 5. If the oil is above the FULL mark, drain the excess engine oil from the drain plug (P), and check the oil level again. 6.
If the oil level is correct, tighten the oil filler cap securely and close the engine cover. REMARKS When checking the oil level after the engine has been operated, wait for at least 15 minutes after stopping the engine before checking. If the machine is at an angle, make it horizontal before checking. 12.2.4 CHECK AND REFILL OF OIL IN BRAKE OIL TANK WARNING Always use engine oil to refill the brake oil tank. Open the inspection cover on the strep on the left side of the machine, and check that the brake oil in the brake tank (1) is between the MAX and MIN marks, on the gauge at the side of the tank. If the oil is below the MIN mark, remove cap (2) and add engine oil.
For details of the oil to use, see “ 20. USE OF FUEL, COOLANT AND LUBRICANTS ACCORDING TO ABIENT TEMPERATURE”.on page 3-10 2-28