OPERATION OPERATION ADJUSTMENT ADJUST OPERATOR'S SEAT Adjust the seat position at the beginning of each shift or when operators change. WARNING Adjust the seat so that the brake pedal can be depressed all the way with the operator’s back against the backrest. (A) Fore-and-aft adjustment Pull lever (1), set the seat to a position where it is easy to oper- ate, then release the lever. Fore-aft adjustment: 160mm (6.3in) (8 stages) (B) Weight adjustment of seat Turn knob (2) under the seat to match the weight adjustment scale with your own weight. The weight can be adjusted to 50 to 120kg (110 to 265lb).
REMARK If you want to make the seat softer, turn the weight adjustment to a lower weight; if you want to make the seat harder, adjust to a higher weight.When operating on uneven surfaces, adjust the seat to a harder setting. (C) Adjuster reclining angle NOTICE When reclining the seat back to the rear, check the space behind, and adjust to a suitable position. Pull lever (3), set the seatback to a position where it is easy to operate, then release the lever. (D) Seat angle adjustment Front angle adjustment of seat (5 stages) To raise the front of the seat, apply your weight to the seat back, pulling up lever (4).
To lower the front of the seat, apply your weight to the front of the seat, pulling up lever (4). Rear angle adjustment of seat (5 stages) To raise the rear of the seat, stand up on your feet a little, pulling up lever (5). To lower the rear of the seat, apply your weight to the rear of the seat, pulling up lever (5). (E) Seat height adjustment Pull up levers (4) and (5) alternately to adjust the angle of the seat. Then, release the levers to lock the seat. (Height adjustment distance: 5 stages, 60mm (2.4in)) 3-55