Storage II In freezing weather, drain CQoling system, or refill it with coolant con- • Short-duration storage o Care of machine to be stored • Long-duration storage • Store machine in a dry garage even if it is to be left standing for a short period of time. If machine has to be left outdoors, cover engine room and operator's seat with canvas or the like. .. If machine is to be stored for a long period of time, proceed as follows: taining more anti-freeze. o Care of machine during storage Wash machine clean, and store it in a dry garage. If machine has to be left outdoors, place it on blocks on level ground and cover it for protec- tion against dust and moisture.
At least once a month, start engine, and move machine and implement. This will circulate oil and prevent rusting from condensation. • Renew oil film once a week by run- ning engine until it is thoroughly warm. This will circulate oil and prevent rusting from condensation. If preservative oil is to be used in engine, attach a tag reading "No Engine Oil" at an easy-to-recognize place. • When moving implement, wipe grease off hydraulic cylinder piston rods. After moving, apply grease. • Drain cooling system if temperature will be below freezing and no anti- freeze is used in the system. When the system is drained, attach "No Coolant" tag to starter switch.
• Recharge battery at lease once a month. • Lubricate all grease fittings and change oils in all compartments. o Care of machine to be released from storage • Apply a thick coat of rust-preventive oil to exposed sliding surfaces of hydraulic cylinder piston rods' and control1inkages. • Remove drain plug from each com- ' .. partment, and allow moisture and sediment to drain. Check oil level, adding oil if necessary. • Disconnect battery cables and cover battery, or dismount battery and store it in a dry, cool place. • Wipe off rust-preventive grease. Start engine, and warm it up thor- oughly to circulate oil.
• Lock all control levers in NEU- TRAL, and place accelerator lever in IDLING position. A WARNING" • Block tracks instead of locking brake pedal. Start and operate engine only in well ventilated area. '1'1// 502750