Basic components adjuster counterclockwise. EWM00030 WARNING Do not overtighten the friction adjuster. If there is too much resistance, it could be difficult to move throttle lever or grip, which could result in an accident. 1. Fully open 2. Fully closed EMU26221 Choke switch To activate the choke system, press in the main switch while the key is turned to the ” (on) or “ ” (start) position. The choke system will then supply the rich fuel mixture required to start the engine. When the key is released, the choke will switch off automatically. When constant speed is desired, tighten the adjuster to maintain the desired throttle set- ting.
EMU25990 Engine stop lanyard switch The lock plate must be attached to the en- gine stop switch for the engine to run. The lanyard should be attached to a secure place on the operator’s clothing, or arm or leg. Should the operator fall overboard or leave the helm, the lanyard will pull out the lock plate, stopping ignition to the engine. This will prevent the boat from running away un- der power. ZMU03160 EMU25970 Throttle friction adjuster A friction device provides adjustable resis- tance to movement of the throttle grip or the remote control lever, and can be set accord- ing to operator preference. To increase resistance, turn the adjuster clockwise.
To decrease resistance, turn the EWM00120 WARNING G Attach the engine stop switch lanyard to a secure place on your clothing, or your arm or leg while operating. G Do not attach the lanyard to clothing that could tear loose. Do not route the lanyard where it could become entan- gled, preventing it from functioning. G Avoid accidentally pulling the lanyard 12