Yamaha Motor Corporation, USA 115D — Transporting and Storing Outboard Motor

Maintenance page 44. 2. Fill the fuel tank with fresh fuel and add one ounce of “Yamaha Fuel Conditioner and Stabilizer” (Part No. LUB-FUELC- 12-00) to each gallon of fuel. NOTE: The use of “Yamaha Fuel Conditioner and Stabilizer” eliminates the need to drain the fuel system. Consult your Yamaha dealer or other qualified mechanic if the fuel system is to be drained instead. 1. Flushing attachment 3. Remove the top cowling and silencer cover/cap. Remove the propeller. 4. Install the flushing attachment over the cooling water inlet. 5. Cooling system flushing is essential to prevent the cooling system from clog- ging up with salt, sand, or dirt.

In addi- tion, fogging/lubricating of the engine is mandatory to prevent excessive engine damage due to rust. Perform the flush- ing and fogging at the same time. ECM00300 Do not run the engine without supplying it with cooling water. Either the engine water pump will be damaged or the en- gine will be damaged from overheating. Before starting the engine, be sure to supply water to the cooling water passag- es. CAUTION: EWM00090 G Do not touch or remove electrical parts when starting or during operation. WARNING G Keep hands, hair, and clothes away from the flywheel and other rotating parts while the engine is running. ECM00310 CAUTION:

Avoid running the outboard motor at high speed while on the flushing attachment, otherwise overheating could occur. 6. Run the engine at a fast idle for 10–15 minutes in neutral position while supply- ing fresh water. 7. Just prior to turning off the engine, quick- ly spray “Yamaha Stor-Rite Engine Fogging Oil” (Part No. LUB-STRRT-12- 00) alternately into each carburetor/ each intake manifold. When properly done, the engine will smoke excessively and almost stall. 8. Remove the flushing attachment and wipe off any excess water. 9. Install the silencer cover/cap and top cowling. Install the propeller. 42