Maintenance tilled water. 3. Store the battery on a level surface in a cool, dry, well-ventilated place out of di- rect sunlight. 4. Once a month, check the specific gravity of the electrolyte and recharge as re- quired to prolong battery life. and let the water flush through the cool- ing passages for about 15 minutes. Turn off the water and disconnect the garden hose. 4. When flushing is complete, reinstall the garden hose connector on the fitting on the bottom cowling. Tighten the connec- tor securely. EMU28440 Flushing power unit Perform this procedure right after operation for the most thorough flushing. 1.
After shutting off the engine, unscrew the garden hose connector from the fit- ting on the bottom cowling. ECM00540 Do not leave the garden hose connector loose on the bottom cowling fitting or let the hose hang free during normal opera- tion. Water will leak out of the connector instead of cooling the engine, which can cause serious overheating. Be sure the connector is tightened securely on the fit- ting after flushing the engine. 1 2 3 NOTE: G When flushing the engine with the boat in the water, tilting up the outboard motor un- til it is completely out of the water will achieve better results.
G For cooling system flushing instructions, EMU28450 Cleaning the outboard motor After use, wash the exterior of the outboard motor with fresh water. Flush the cooling system with fresh water. see page 41. ZMU04148 1. Fitting 2. Garden hose connector 3. Garden hose 2. Screw the garden hose connector onto a garden hose which is connected to a fresh water supply. 3. With the engine off, turn on the water tap ZMU02550 44 CAUTION: