Yamaha Motor Corporation, USA 115D — Checking Wiring and Connectors

Maintenance cup. Firmly screw the cup onto the filter housing. 5. Attach the filter assembly to the bracket so that the fuel hoses are attached to the filter assembly. 6. Run the engine and check the filter and lines for leaks. NOTE: Correct idling speed inspection is only possi- ble if the engine is fully warmed up. If not warmed up fully, the idle speed will measure higher than normal. If you have difficulty ver- ifying the idle speed, or the idle speed re- quires adjustment, consult a Yamaha dealer or other qualified mechanic. EMU29040 Inspecting idling speed EWM00450 2. Verify whether the idle speed is set to specification. For idle speed specifica- tions, see page 40.

G Do not touch or remove electrical parts when starting or during operation. WARNING G Keep hands, hair, and clothes away from the flywheel and other rotating parts while the engine is running. EMU29050 Checking water in engine oil tank Oil injection models There is a water trap at the bottom of the en- gine oil tank. If water or foreign matter is vis- ible in this trap, consult your Yamaha dealer. G 2-hp models: The propeller rotates whenever the engine is running. Do not move the throttle control lever from the start position during warm-up. The boat could unexpectedly start to move, which could result in an accident.

ECM00490 2 1 This procedure must be performed while the outboard motor is in the water. A flushing attachment or test tank can be used. CAUTION: 1. Water trap 2. Engine oil tank ZMU01895 A diagnostic tachometer should be used for this procedure. Results may vary depending on whether testing is conducted with the flushing attachment, in a test tank, or with the outboard motor in the water. 1. Start the engine and allow it to warm up fully in neutral until it is running smooth- ly. 2-hp model: Warm the engine with the throttle in the start position or less. If the outboard is mounted on a boat, be sure the boat is tightly moored.

EMU29111 Checking wiring and connectors G Check that each grounding wire is properly secured. G Check that each connector is engaged se- curely. 51