Yamaha Motor Corporation, USA 115D — Temporary Action in Emergency

Trouble Recovery EMU29531 Starter will not operate If the starter mechanism does not operate (the engine cannot be cranked with the start- er), the engine can be started with an emer- gency starter rope. 2 EWM01020 1 G Use this procedure only in an emergen- cy and only to return to port for repairs. WARNING ZMU04152 1. Fuse holder 2. Fuse (20 A, 30 A) G When the emergency starter rope is used to start the engine, the start-in- gear protection device does not oper- ate. Make sure the remote control lever is in neutral. Otherwise the boat could unexpectedly start to move, which could result in an accident. NOTE: Consult your Yamaha dealer if the new fuse immediately blows again.

EMU29520 Power trim and tilt will not operate If the engine cannot be tilted up or down with the power trim and tilt/ the power tilt because of a discharged battery or a failure with the power trim and tilt unit/the power tilt, the en- gine can be tilted manually. 1. Loosen the manual valve screw by turn- ing it counterclockwise until it stops. G Attach the engine stop switch lanyard to a secure place on your clothing, or your arm or leg while operating. G Do not attach the lanyard to clothing that could tear loose. Do not route the cord where it could become entangled, preventing it from functioning. G Avoid accidentally pulling the lanyard during normal operation.

Loss of en- gine power means the loss of most steering control. Also, without engine power, the boat could slow rapidly. This could cause people and objects in the boat to be thrown forward. 1 G Be sure no one is standing behind you when pulling the starter rope. It could whip behind you and injure someone. ZMU03464 G An unguarded, rotating flywheel is very dangerous. Keep loose clothing and other objects away when starting the engine. Use the emergency starter rope only as instructed. Do not touch the fly- wheel or other moving parts when the engine is running. Do not install the 1. Manual valve screw 2.

Put the engine in the desired position, then tighten the manual valve screw by turning it clockwise. 63