27 31 30 29 28 33 32 24 25, 26 23 22 3 36 14 15 16 21 13 17 18 19 20 12 11 9 5 6 7 4 10 3 8 37 1 35 34 2 14072SF70 1 Body(1) 2 Body(2) 3 Plug 4 Plug 5 Spring seat 6 Spring 7 Spring seat 8 Spool 9 Stopper 10 Spring 11 Rod guide 12 O-ring 13 Snap ring 14 Push rod 15 Spring pin 16 Seal 17 Steel ball 18 Spring 19 Plate 20 Snap ring 21 Plug 22 O-ring 23 Rod seal 24 Dust seal 25 Cover 26 Bolt 27 Cam 28 Bushing 29 Cam shaft 30 Set screw 31 Set screw 32 Nut 33 Bellows 34 Space 35 O-ring 36 O-ring 37 Bolt 2-88 CROSS SECTION The construction of the RCV pedal is shown in the below drawing. The casing has vertical holes in which reducing valves are assembled.
The pressure reducing section is composed of the spool(8), spring(6) for setting secondary pressure, return spring(10), stopper(9), and spring seat(7). The spring for setting the secondary pressure has been generally so preset that the secondary pressure is 5 to 19 kgf/cm2(depending on the type). The spool is pushed against the push rod(14) by the return spring. When the push rod is pushed down by tilting pedal, the spring seat comes down simultaneously and changes setting of the secondary pressure spring.