6. WHEN ENGINE OIL PRESSURE WARNING LAMP LIGHTS UP (Engine is started) Before disconnecting the connector, always turn the starting switch OFF. Before carrying out below procedure, check all the related connectors are properly inserted. After checking, insert the disconnected connectors again immediately unless otherwise specified. Check resistance 51076ES04 6-29 YES Is the CAN YES communication between MCU and ECM? Starting switch : ON YES Does the gauge Check resistance light up and between down at lamp NO CN-98 (A-B) & check? CN-99 (A- B) NO Starting switch : ON Spec : 120 NO Cause Remedy Disconnection in wiring harness or poor contact between ECM-engine oil pressare switch.
Defective controller or ECM Defective wiring harness Defective cluster Repair or replace (After clean) Replace Replace Replace YES MAX 1 NO MIN 1M