hyundai R510LC-7 — 4. MECHATRONICS SYSTEM

2) TEST PROCEDURE SPEC : 17.5 1 (20 C) (1) Test 1 : Check resistance at connector CN-75. Starting key OFF. Disconnect connector CN-75 from EPPR valve at main hydraulic pump. Check resistance between 2 lines as figure. CN-75 Multimeter EPPR valve 2507A5MS11 (2) Test 2 : Check electric current at EPPR valve. Install multimeter as figure. Start engine. Set the accel dial at "10"(MAX) Set H-mode and cancel auto decel mode. If tachometer show approx 1700 SPEC : 200~450 mA (S mode) Multimeter CN-75 50 rpm , check electric current. EPPR valve 2507A5MS08 (3) Test 3 : Check pressure at EPPR valve. Remove plug and connect pressure gauge as figure. SPEC :

5~20 kgf/cm 2 (70~280 psi ) Pressure adjusting screw locknut Gauge capacity : 0 to 40~50 kgf/cm 2 CN-75 Supply line, pilot pressure (0 to 570~710 psi ) Start engine. Set the accel dial at "10"(Max). Set H-mode and cancel auto decel mode. If tachometer show approx 1700 EPPR valve 50 rpm , check pressure. If pressure is not correct, adjust it. After adjust, test the machine. 2507A5MS09 6-41