14) FOR TRAVEL SPEED SELECTING PRESSURE (1) Preparation Stop the engine. Remove the top cover of the hydraulic tank oil supply port with a wrench. Push the pressure release button to bleed air. To measure the speed selecting pressure: Install a connector and pressure gauge assembly to turning joint P port as shown. Start the engine and check for on leakage from the adapter. Keep the hydraulic oil temperature at 50 5 C. (2) Measurement Select the following switch positions. Travel mode switch : 1 speed 2 speed Mode selector : M mode Measure the travel speed selecting pressure in the Hi or Lo mode. Lower the bucket to the ground to raise the track off the ground.
Operate the travel lever at full stroke and measure the fast speed pressure. Repeat steps 45077MS02 three times and calculate the average values. and (3) Evaluation The average measured pressure should be within the following specifications. Unit : kgf / cm 2 7-17 Model Travel speed mode Standard Maximum allowable Remarks R510LC-7 1 Speed 0 - 2 Speed 33 5 -