2. MAIN CONTROL VALVE 2. MAIN CONTROL VALVE 7-22 Part name Inspection item Criteria & measure Casing ÂExistence of scratch, rusting or corrosion. ÂIn case of damage in following section, replace part. - Sliding sections of casing fore and spool, especially land sections applied with holded pressure. - Seal pocket section where spool is inserted. - Sealing section of port where O-ring contacts. - Sealing section of each relief valve for main, travel and port. - Other damages that may damage normal functions. Spool ÂExistence of scratch, gnawing, rusting or corrosion. ÂO-ring seal sections at both ends. ÂInsert spool into casing hole, rotate and reciprocate it.
ÂReplacement when its outside sliding section has scratch (especially on seals- contacting section). ÂReplacement when its sliding section has scratch. ÂCorrection or replacement when O-ring is damaged or when spool does not move smoothly. Poppet ÂDamage of poppet or spring. ÂInsert poppet into casing and function it. ÂCorrection or replacement when sealing is incomplete. ÂNormal when it can function lightly without being caught. Around spring ÂRusting, corrosion, deformation or breaking of spring, spring seat, plug or cover. ÂReplacement for significant damage. Around seal for spool ÂExternal oil leakage. ÂRusting, corrosion or deformation of seal plate. ÂCorrection or replacement.
ÂCorrection or replacement. Main relief valve, port relief valve & negative control relief valve ÂExternal rusting or damage. ÂContacting face of valve seat. ÂContacting face of poppet. ÂAbnormal spring. ÂO-rings, back up rings and seals. ÂReplacement. ÂReplacement when damaged. ÂReplacement when damaged. ÂReplacement. Â100% replacement in general.