hyundai R510LC-7 — 2. MAJOR COMPONENT

4. TRAVEL MOTOR 4. TRAVEL MOTOR Replace parts in accordance with the following standards. However, if a part is damaged significantly in terms of its appearance, replace it irrespective of the standards.

HYDRAULIC MOTOR HYDRAULIC MOTOR 1) 1) 7-25 Part name & inspection item Standard dimension Recommended value for replacement Remedy Clearance between piston & cylinder bore (D-d) 0.052 mm 0.077 mm Replacement Clearance caulked part between piston andshoe (ɺ) 0.1 mm 0.3 mm Replacement Thickness of shoe 7.5 mm 7.3 mm Replacement Assembled height of spherical bush andset plate (H-h) 26.5 mm 26.0 mm Replacement as a set Free length of cylinder spring 68.0 mm 67.4 mm Replacement Shaft over pin dia. Output spline Cylinder spline 51.402 (͚4.5) 58.878 (͚4.5) 52.002 mm 59.478 mm Replacement if either one reaches replacement value. Spline over dia.

Spline in cylinder Spline in spherical bushing 42.302 (͚6) 42.902 mm Replacement Thickness of separation plate Thickness of friction plate 2.43 mm 3.9 mm 2.23 mm 3.7 mm Replacement Free length of brake spring 39.77 mm 38.77 mm Replacement Displacement over teeth Over pin dia. of friction plate internal teeth 68.77 (8teeth) 173.67 (͚5) 68.47 mm 174.27 mm Replacement Replacement Roughness of sliding surfaces Swash plate/shoe Cylinder block/valve plate 0.4 - z 0.4 - z 3 - z 3 - z Each independent lapping Mutual lapping Roller bearing Needle bearing - - Replacement if flaking is found on rolling surface. O-ring Oil seal - - Replacement at every disassembly, in principle.