hyundai R510LC-7 — 2. MAJOR COMPONENT

7-28 Part name & inspection item Standard dimension Recommended value for replacement Remedy Backlash of spline contact part 0.1-0.3 mm 0.5 mm Replacement as a recommended value for replacement. Thrust ring 90 Thickness 8 mm 7.6 mm Replacement if severe wear or seizure is found on sliding surface. Floating seal - - Replacement of scratch or rust is found in sliding surface. Replacement if O-ring is deformed of damaged. Gear oil - - 1st time : 500hr 2nd time and later : Every 2000hr After disassembling, fill with new oil without fail. (The above times are measured with engine hour meter.)