hyundai R510LC-7 — 3. PUMP DEVICE

(7) Place pump horizontally on workbench with its regulator-fitting surface down, and separate pump casing(271) from valve cover(F, 311). Before bringing this surface down, spread rubber sheet on workbench without fail to prevent this surface from being damaged. 36078MP03 (8) Separate valve cover(F, 311) from valve cover(R, 312) and pull out booster(130), spline coupling(114). (9) Separate valve cover(R, 312) from pump casing and then pull out the cylinder block(012) of pump casing(271) straightly over drive shaft(R, 113). Pull out also pistons(151), set plate(153), spherical bush(156) and cylinder springs (157) simultaneously.

Take care not to damage sliding surfaces of cylinder, spherical bushing, shoes, swash plate, etc. 36078MP04 (10) Remove hexagon socket head bolts(406) and then seal cover(F, 261). Fit bolt into pulling-out tapped hole of seal cover(F), and cover can be removed easily. Since oil seal is fitted on seal cover(F), take care not to damage it when removing cover. 36078MP05 8-13