hyundai R510LC-7 — 6. TRAVEL DEVICE

4. DISASSEMBLING 4. DISASSEMBLING 1) 1) GENERAL PRECAUTIONS GENERAL PRECAUTIONS (1) Pay attention to not damaging contact surfaces for O-rings, oil seals, etc. and contact/sliding surfaces for gears, pins, bearings, etc. (2) This motor can be disassembled even in a state on the reduction gear. However, in that case, pay full attention to preventing mud, dust, etc. from entering in it. (3) The numerical in parentheses following each part name indicates its part number shown in the attached assembly drawings. assembly drawings. (4) The piping side of the motor is referred to as the rear side, and the output side as the front side.

2) 2) DISASSEMBLY OF REDUCTION GEAR DISASSEMBLY OF REDUCTION GEAR (1) ц ц Select a disassembling place. Select a clean place. Spread rubber sheet or cloth on work bench to prevent parts from being damaged. (2) Remove dust, mud, etc. from reduction gear surfaces with washing oil or so. (3) Place reduction gear with its gear oil drain port or level gauge at the lowest position, and drain reduction gear oil. Receive gear oil with clean vessel and check it for abnormalities. Renew gear oil. ц Place reduction gear with its side cover (180) upward, than remove socket bolt (185). Don't reuse thrust washer (181) in cover. (4) ц (5) ц Remove cover (180) from ring gear (114).

Mount two eyebolt (PF 1/2), then lift it using crame. 480H8TM02 8-98 480H8TM01