2. PRINCIPLE OF DRIVING 2. PRINCIPLE OF DRIVING 2.1 Generating the turning force The high hydraulic supplied from a hydraulic pump flows into a cylinder (10) through valve casing of motor (21), and valve plate (24). The high hydraulic is built as flowing on one side of Y-Y line connected by the upper and lower sides of piston (14). The high hydraulic can generate the force, F1=P Э A (P : supplied pressure, A : water pressure area), like following pictures, working on a piston. This force, F1, is divided as N1 thrust partial pressure and W1 radial partial pressure, in case of the plate of a tilt angle, ɷ .
W1 generates torque, T=W1+R1, for Y-Y line connected by the upper and lower sides of the piston as following pictures. The sum of torque ( ɨ W1 Э R1), generated from each piston (4~5 pieces) on the side of a high hydraulic, generates the turning force. This torque transfers the turning force to a cylinder (10) through a piston; because a cylinder is combined with a turning axis and spline, a turning axis rotates and a turning force is sent. Y Low pressure High pressure Y 21078TM05 2-61 W1 R1 Pistion Cylinder W1 N1 O f1 F1 A P Cylinder N1 F1 A P