honda — Programmed Fuel Injection

BF135A•BF150A Apply the recommended engine oil to the O-rings before installation. Avoid using the vegetable oil and the alco- holic grease. 1. SERVICE PRECAUTIONS • PGM-FI (PROGRAMMED FUEL INJECTION) TROUBLESHOOTING First, check the MIL of the indicator. Be sure to turn the ignition switch OFF before discon- necting and connecting the ECM connector. After inspection and repair, clear the DTC (P. 5-14) or reset the ECM memory (P. 5-57). O-RING INJECTOR • CHECK AFTER OPERATION Check the parts for secure installation and the bolts, screws and other fasteners for secure tightening. Connect the battery cable to the battery negative (–) ter- minal.

PGM-FI MIL • FUEL LINE SERVICE Do not smoke while working on the fuel system. Keep open flame or sparks away from the work area. Disconnect the battery cable from the battery negative (–) terminal. Before removing and installing the fuel line, relieve the fuel pressure by loosening the service check bolt of the high pressure side fuel strainer, as described in “How to relieve fuel pressure” (P. 5-102). • FUEL LEAK CHECK Turn the ignition switch ON (but do not turn the starter) after connecting the fuel lines. The fuel pump unit (high pressure side) should operate for approximately 2 sec- onds and the fuel pressure in the high pressure side fuel line should rise.

Repeat this operation 2 or 3 times and check for fuel leakage. • WHEN THE BOAT IS EQUIPPED WITH RADIO EQUIPMENT The ECM and its wires are designed to be unaffected by radio waves. However, the ECM can malfunction when it senses an extremely powerful electric wave. Note the fol- lowing to avoid malfunction of the ECM. Install the antenna and the body of the radio equipment at least 50 cm (20.0 in) away from the ECM, remote con- trol cable A and the remote control box. Antenna wire must not be too long. Do not route the antenna wire along the remote control cable A and other cables/wires. Do not mount the radio equipment of large output power on the boat.

(The maximum output power of the radio equipment should be 10W when mounted on a boat.) Install the D-GPS antenna and the body unit at least 3 m (10 ft) away from the engine. Connect the D-GPS antenna ground wire to ground. SHOP TOWEL SERVICE CHECK BOLT 12 N m (1.2 kgf m, 9 lbf ft) Replace the sealing washers during reassembly. Replace the O-rings when the fuel line is removed/ installed or replaced. 5-2