honda — Programmed Fuel Injection

BF135A•BF150A 5-9 ECM CONNECTOR B HARNESS SIDE CONNECTOR VIEWED FROM THE TERMINAL SIDE Terminal No. Wire color Terminal mark Name Content/Signal 1 Not used 2 G TDC CMP sensor CMP sensor signal 3 Bu CRK CKP sensor CKP sensor signal 4 Br/Y VCC1 Sensor power 1 Power for sensor (5V) 5 W/R PB MAP sensor Detects vacuum at the intake manifold. 6 G/R SG1 Sensor ground 1 7 R/Bl THL TP sensor Detects throttle position. 8 R/W TE ECT sensor 1 Detects cylinder block engine temperature. 9 Not used 10 Lg/R FLR1 Fuel pump relay 1 Power to drive fuel pump relay 11 R/Y TA IAT sensor Detects intake air temperature. 12 R/Bl TOH1 ECT sensor 2 Detects cylinder head temperature.

13 R/Bu NTSW Neutral switch At switch ON (Neutral): Approx. 0V At switch OFF: Battery voltage 14 P OPSL EOP switch (Low pressure side) At switch ON: Approx. 0V At switch OFF: Battery voltage 15 Bu K-LINE Communication signal At ignition switch ON: Approx. 12V 16 Lg/W SCS Service check signal 17 G/Bl LG1 Logic ground 1 18 Y/G BUZZ Buzzer Power to sound buzzer 19 W/Bu ACGL Alternator indicator light Inputs alternator indicator light ON signal. 20 Bl/R EMS1 Emergency stop switch 1 At switch ON: Approx. 0V At switch OFF: Battery voltage 21 Br INJ1 No. 1 injector Power to drive No. 1 injector 22 Bu IGN1 No. 1 ignition coil Outputs No. 1 ignition signal. 23 R INJ2 No. 2 injector Power to drive No.

2 injector 24 Bu/Bl IGN2 No. 2 ignition coil Outputs No. 2 ignition signal. 25 R/Bu WARNL MIL Power to turn MIL ON 26 G/W EACVP IAC valve (+) Power to drive IAC valve (+) 27 Bu INJ3 No. 3 injector Power to drive No. 3 injector 28 W/G IGN3 No. 3 ignition coil Outputs No. 3 ignition signal 29 Y INJ4 No. 4 injector Power to drive No. 4 injector 30 Bu/R IGN4 No. 4 ignition signal Outputs No. 4 ignition signal 31 R OHL Overheat indicator light Overheat indicator light ON line 32 Y OPL Oil pressure light Oil indicator light ON line 33 Gr TACHO Tachometer pulse Drives tachometer. 34 Bl EACVM IAC valve (–) Power to drive IAC valve (–)