honda — Programmed Fuel Injection

BF135A•BF150A 4. Heater line short circuit check -1. Turn the ignition switch OFF and disconnect the ECM connector C. -2. Check for the continuity between the No. 3 (Black/White) terminal of the ECM connector C and the engine ground, and between the No. 4 (White) ter- minal of the ECM connector C and the engine ground. DTC 41-4: A/F sensor heater is abnormal 1. Symptom reproduction test -1. Connect the HDS pocket tester and clear the DTC once. If the DTC can not be cleared, go on the trou- bleshooting. -2. Start the engine and warm it up for 5 minutes or more by running the engine at 3,000 min -1 (rpm) under no load. -3. Check the DTC again using the HDS pocket tester.

ECM CONNECTOR C AFHT (BLACK/WHITE) AFHT+ (WHITE) Does the DTC 41-4 appear? YES – Perform “2. A/F heater relay check”. NO – Temporary failure (Disappeared) 2. A/F heater relay check -1. Turn the ignition switch OFF and disconnect the A/F sensor 4P connector. -2. Turn the ignition switch ON. Measure the voltage between the No. 3 (White) terminal of the A/F sensor harness side 4P connector and the engine ground. VIEWED FROM THE TERMINAL SIDE Is there the continuity? YES – Repair short in the wire between the A/F sen- sor and the ECM. NO – Perform “5. Heater line open circuit check”. A/F SENSOR HARNESS SIDE 4P CONNECTOR 5. Heater line open circuit check -1.

Turn the ignition switch OFF and connect the A/F sen- sor 4P connector. -2. Measure the resistance between the No. 3 (Black/White) and the No. 4 (White) terminals of the ECM connector C. AFHT+ (WHITE) VIEWED FROM THE TERMINAL SIDE ECM CONNECTOR C Is there the battery voltage? YES – Perform “3. A/F heater harness check”. NO – Go to the step 3. AFHT (BLACK/WHITE) AFHT+ (WHITE) -3. Turn the ignition switch OFF and disconnect the A/F heater relay 4P connector. -4. Measure the voltage between the No. 1 (White/ Green) terminal of the A/F heater relay harness side 4P con- nector and the engine ground. Note that the battery voltage is constantly applied to the White/Green terminal.

Take care not to short-circuit the terminal. VIEWED FROM THE TERMINAL SIDE Is the resistance 2 – 3 (at room temperature)? YES – Replace the A/F sensor and recheck. If it is still abnormal, substitute a known-good ECM and recheck. NO – Repair open in the wire between the A/F sen- sor and the ECM. A/F HEATER RELAY HARNESS SIDE 4P CONNECTOR +B (WHITE/GREEN) VIEWED FROM THE TERMINAL SIDE 5-46