BF135A•BF150A c. STARTING SYSTEM • ENGINE DOES NOT START Before starting troubleshooting, check each wire for connection and correct as necessary. Not in “N” (Neutral) position. Move the remote control lever in the “N” (Neutral) position. Does not turn. Check the overrunning clutch and replace as nec- essary. Check the starter motor magnetic clutch and replace as necessary. Check the planetary gear and replace as necessary. Check by sound whether the starter motor is turning. Is the starter motor turning? YES Check the No. 3 (10A) fuse and the No. 7 (30A) fuse. Are the fuses normal? NO Replace the blown fuse(s).
Remove the cause of the blown fuse(s) before replace- ment (see FUSE LOAD CHART on P. 2-20). Check the battery for charging level. Is the battery fully charged? NO Perform charging system troubleshooting (P. 2-29). Check the battery terminals for con- nection and corrosion. Are the battery terminals in good condition NO Remove corrosion from the terminals and connect the ter- minals securely. Check the neutral switch (P. 17-13). Is the switch in good condition? NO Replace the neutral switch. Check the PGM-FI main relay (P. 18- 24). Is the PGM-FI main relay in good condition? Replace the PGM-FI main relay. NO To P. 2-24 (A). To P. 2-24 (B).
2-23 Check whether the remote control lever is in the “N” (Neutral) position. In “N” (Neut ral) position. Check whether the engine turns with the ignition switch in the “START” posi- tion. N O Engin e turns. Y ES Y ES Y ES Y ES Y ES