1. REMOVAL Remove the following pars. – Engine cover (P. 4-2). – L./R. engine under covers (P. 4-9). – Under cover front bracket/L./R. side cover brackets (P. 4-20). – Vapor separator (P. 5-111). – Gear case assembly (P. 14-3 and 42). 1) Hook the hoist hooks on the three engine hangers and secure the engine not to fall down. Remove the following parts. – Extension case/lower rubber mount (P. 14-89). – Oil case (P. 14-94). 2) Be sure that the engine is held vertically and remove the following parts. – Starter motor (P. 18-1). – Starter cable (P. 18-15). – Shift link bracket/neutral switch (P. 17-11).
[1] ENGINE HANGER (3) 3) Remove the two 6 x 20 mm flange bolts and remove the seal holder assembly from the engine assembly. 6 x 20 [1] SEAL HOLDER ASSEBLY 4) Disconnect the air vent tube A and the oil tube from the mounting case. [1] AIR VENT TUBE A [2] OIL TUBE 7-2