honda — Engine Removal/Installation

9) Remove the following bolts and washers from the underside of the mounting case. 8 x 100 mm flange bolt (1) 10 x 80 mm flange bolt (1) 10 x 110 mm flange bolts (2) 12 x 70 mm hex. bolt (1) 12 x 130 mm hex. bolts (2) 12 mm washers (3) 10) Lift up the engine assembly slowly and remove it from the mounting case. NOTICE Be sure that the hoist hooks are set on the three engine hangers securely. Lift up the engine assembly while holding the engine vertically. 11) Remove the two dowel pins, mounting case gasket, exhaust guide gasket and the oil pump rubber.

[1] ENGINE ASSEMBLY [9] MOUNTING CASE GASKET [2] 10 x 16 mm DOWEL PIN [8] OIL PUMP RUBBER [3] EXHAUST GUIDE GASKET [7] 14 x 20 mm DOWEL PIN [4] 12 mm WASHER (3) [6] 12 x 70 mm HEX. BOLT 10 x 80 [5] 12 x 130 mm HEX. BOLT (2) 10 x 110 (2) 8 x 100 7-4