1. CYLINDER HEAD COVER REMOVAL Remove the following parts. – Engine cover (P. 4-2) – L./R. engine under covers (P. 4-9) – Ignition coil/spark plug (P. 3-6) 1) Disconnect the breather tube and the main wire harness from the cylinder head cover. [1] BREATHER TUBE [2] MAIN WIRE HARNESS 2) Remove the two 6 x 22 mm flange bolts, then remove the R. side cover bracket assembly from the engine assembly. [1] R. SIDE COVER BRACKET ASSEMBLY 6 x 22 (2) 3) Disconnect the fuel tube B and the fuel tube D from the fuel pump (low pressure side).
[1] TUBE CLIPS (Commercially available) [2] FUEL TUBE B NOTICE Before disconnecting the fuel tube B and the fuel tube D, clamp the fuel tubes with the tube clips to prevent gasoline leakage. [3] FUEL PUMP (Low pressure side) [4] FUEL TUBE D 10-2