honda — Oil Pump/Flywheel

10) Then, tighten it to the specified torque using the same special tool as that used during disassembly. TOOL: Oil filter wrench 07HAA-PJ70101 TORQUE: 12 N . m (1.2 kgf . m, 9 lbf . ft) [1] OIL FILTER WRENCH 07HAA-PJ70101 11) Before installing the EOP switch (low pressure side), clean the switch and apply the liquid gasket (ThreeBond ® #1215 or equivalent) to the area shown. NOTICE Take care not to put the liquid gasket on the switch end and the oil passage. [1] APPLICATION AREA 12) Tighten the EOP switch (low pressure side) to the specified torque using the torque wrench. [1] EOP SWITCH TERMINAL TORQUE: 8 N . m (0.8 kgf . m, 5.8 lbf .

ft) NOTICE Use the torque wrench to tighten the EOP switch (low pressure side). Do not overtighten the EOP switch as it can damage the oil filter flange. 13) Connect the EOP switch terminal to the EOP switch (low pressure side). 14) Add the specified amount of the engine oil (P. 3-2). After adding the oil, check each joint for oil leakage. 15) Install the following parts. – L./R. engine under covers (P. 4-14) – Engine cover (P. 4-2) [2] EOP SWITCH (LOW PRESSURE SIDE) 11-5