c. INSPECTION Check the ring gear for wear and damage. If it is worn or damaged, check the starter motor pinion gear. [1] FLYWHEEL [2] RING GEAR d. INSTALLATION 1) Clean the crankshaft and flywheel mating surfaces thoroughly with the degreasing cleaning agent. 2) Apply engine oil to the threads and seating surface of the 12 mm bolts. ① ⑦ ⑤ ④ 3) Install the flywheel on the crankshaft and loosely tighten the eight 12 mm bolts. Install the special tool, that had been used for removal, on the starter motor mounting part (P. 11- 12). 4) Tighten the 12 mm bolts to the specified torque in the numbered sequence in two or three steps. ③ ⑥ ② ⑧ TORQUE: 118 N . m (12.0 kgf . m, 87 lbf .
ft) 5) Clean the flywheel and flywheel boss mating surfaces thoroughly with the degreasing cleaning agent. 6) Apply engine oil to the threads and seating surface of the 8 mm special bolts. 7) Install the flywheel boss on the flywheel and loosely tighten the eight 8 mm special bolts. 8) Tighten the 8 mm special bolts to the specified torque in the numbered sequence in two to three steps. ① ⑤ ⑦ TORQUE: 32 N . m (3.3 kgf . m, 24 lbf . ft) ③ ④ NOTICE Be sure to clean the mating surfaces of the crankshaft, flywheel and the flywheel boss thoroughly with the degreasing cleaning agent. ⑥ ⑧ 9) Remove the special tool. 10) Install the oil pump body assembly (P. 11-11).
11) Install the engine on the outboard motor (P. 7-6). ② 11-14