1. CRANKCASE/BALANCER CASE ASSEMBLY REMOVAL 6 x 25 (15) Remove the following parts. – Engine cover (P. 4-2) – L./R. engine under covers (P. 4-9) – Silencer case (P. 5-128) – Throttle body/intake manifold (P. 5-129) – Silencer duct (P. 6-2) – Electric parts/main harness (P. 18-1, 15, 19 and 27) 1) Move the remote control lever to the “N” (Neutral) position. 2) Turn the crankshaft pulley clockwise until it sets the No.1 piston at the top dead center of its compression stroke (P. 3-12). Remove the following parts. – Crankshaft pulley/cam chain (P. 9-2) 3) Remove the engine from the outboard motor (P. 7-2). 4) Remove the fifteen 6 x 25 mm flange bolts from the crankcase.
5) Insert the screwdriver into the recesses of the crankcase and raise the crankcase little by little. NOTICE Take care not to damage the crankcase and lower block mating surfaces. 6) Remove the crankcase and the two dowel pins from the lower block. [1] CRANKCASE [2] 13 x 20 mm DOWEL PIN (2) 12-2 [1] RECESS [1] RECESS