honda — Propellor/Gear Case/Extension Case/Oil Case

c. INSTALLATION 1) Place the remote control lever in the “N” (Neutral) position. [1] CUTOUT 2) Check that the shift rod of the gear case is in the “N” (Neutral) position. To check: Check whether the cutout of the shift rod spline faces in the direction shown. [It indicates that the shift rod is in the “N” (Neutral) position.] [3] SHIFT ROD [2] CRUISING DIRECTION 3) If the cutout of the spline is not in the direction shown, protect the spline with a shop towel or equivalent material and turn the shift rod right and left with a wrench until the cutout faces toward the specified direction. SHIFT ROD 4) Tilt up the outboard motor to the uppermost position.

5) Apply grease to the spline of the shift rod A. 6) Install the shift rod A by aligning the projection of the shift shaft A with the cutout in the spline of the shift rod A. Check that the cutout in the spline of the shift rod A is toward the cruising direction. [3] CUTOUT [1] SHIFT SHAFT A [2] PROJECTION [4] CRUISING DIRECTION [4] CRUISING DIRECTION [5] SHIFT ROD A 14-5 [1] SH OP TOWEL