honda — Propellor/Gear Case/Extension Case/Oil Case

c. ASSEMBLY 1) Apply soapy water to the circumference of the 12 x 21 x 6 mm water seals. [1] direction> 2) Drive the 12 x 21 x 6 mm water seals one by one in the shift rod holder using the special tools. Note the installation direction of the water seals. Be sure to apply grease to the water seal mating surfaces before installation. [2] 12 x 21 x 6 mm WATER SEALS TOOLS: Driver 07749-0010000 Oil seal driver attachment, 21 mm 07947-ZV00100 [3] (Apply grease to the water seal mating surfaces and the lips.) 3) After installing the water seals, apply grease to the water seal lips.

[4] DRIVER 07749-0010000 [5] OIL SEAL DRIVER ATTACHMENT, 21 mm 07947-ZV00100 [6] SHIFT ROD HOLDER 4) Position the 10 mm E-ring, 12 mm washer and the shift rod spring on the shift rod. [2] SHIFT ROD SPRING [1] 10 mm E-RING [3] 12 mm WASHER [4] SHIFT ROD 14-12