honda — Propellor/Gear Case/Extension Case/Oil Case

11) Calculate the gap (distance E) between the outer race and inner race using the measurements obtained in step 9 and 10 and the following formula. Formula: Bearing height – Outer race height = Gap (distance E) Example: When, bearing height from the outer race end to the inner race end is 34.9 mm (1.37 in), And, outer race height is 29.7 mm (1.17 in): 34.9 – 29.7 = 5.2 Therefore, the gap (distance E) is 5.2 mm (0.20 in). 12) Determine the calculation value using the vertical shaft length (distance D) obtained in step 7 and the gap (distance E) obtained in step 11 and the following formula. Formula: Vertical shaft length (distance D) + Gap (distance E) – 147.2 = Calculation value Example:

When, vertical shaft length (distance D) is 141.8 mm (5.58 in), And, gap (distance E) is 5.2 mm (0.20 in): 141.8 + 5.2 – 147.2= –0.20 Therefore, the calculation value is –0.20 mm (–0.008 in). [1] GEAR CASE 13) Cross reference the calculation value and the engagement mark located on the trim tab installation part of the gear case, and select the shim of the appropriate thickness from the shim selection table accordingly. Shim type table [2] ENGAGEMENT MARK 14-37 [1] Shim type [2] Thickness [3] Pinion gear shim A 0.10 mm (0.004 in) [4] Pinion gear shim B 0.15 mm (0.006 in) [5] Pinion gear shim C 0.30 mm (0.012 in) [6] Pinion gear shim D 0.50 mm (0.020 in)