honda — Propellor/Gear Case/Extension Case/Oil Case

9. BACKLASH ADJUSTMENT [*1] a. FORWARD BEVEL GEAR BACKLASH Backlash adjustment must be made after adjustment of each gear shim (P. 14-35). Install the parts except the water pump in the gear case (P. 14- 12, 17 and 31). 1) Hold the propeller shaft securely with the special tool as shown, and tighten the puller bolt to the specified torque. TOOLS: Puller jaws 07SPC-ZW0010Z Puller bolt 07SPC-ZW0011Z TORQUE: 5 N . m (0.5 kgf . m, 3.6 lbf . ft) Turn the vertical shaft five to ten turns clockwise to fit the bevel gear bearing.

[1] BACKLASH INDICATOR ATTACHMENT 07SPK-ZW10100 2) Attach the special tool to the vertical shaft as shown, and adjust the dial indicator so its needle is at the line “2” of the special tool (backlash indicator tool). [2] BACKLASH INDICATOR TOOL 07SPJ-ZW0030Z TOOLS: Backlash indicator tool 07SPJ-ZW0030Z Backlash indicator attachment 07SPK-ZW10100 3) Turn the vertical shaft lightly right and left and record the dial indicator reading. Measure the backlash at the four points (by turning the vertical shaft 90˚) in the same manner. NOTICE Do not turn the propeller shaft when turning the vertical shaft.

4) Obtain the forward bevel gear backlash using the dial indicator runout and the following formula. [3] DIAL INDICATOR Adjust the dial indicator needle at line “2” of the backlash indicator tool. Formula: Dial indicator runout ч 0.86 = Backlash [4] VERTICAL SHAFT Example: When dial indicator runout is 0.195 mm (0.0077 in): 0.195 ч 0.86 = 0.23 Therefore, the backlash is 0.23 mm (0.009 in). 5) If the backlash is too large, increase the forward bevel gear shim thickness and recheck the backlash. If the backlash it too small, reduce the forward bevel gear shim thickness and recheck the backlash.

NOTICE Use the special tool when 50 x 90 x 28 mm taper bearing outer race is removed to adjust the backlash again (P. 14- 28). 14-41 BOLT W0011Z [1] PULLER 07SPC-Z [2] PULLER JAWS 07SPC-ZW0010Z Standard value 0.10 – 0.30 mm (0.004 – 0.012 in)