12) Remove the 6 x 12 mm hex. bolt and the pivot washer. Remove the shift rod holder and the shift rod assembly. [1] SHIFT ROD HOLDER [2] SHIFT ROD ASSEMBLY [3] 6 x 12 mm HEX. BOLT [4] PIVOT WASHER 13) Remove the shift rod spring, 12 mm washer and the 10 mm E-ring from the shift rod. [2] SHIFT ROD SPRING [1] 10 mm E-RING [3] 12 mm WASHER [4] SHIFT ROD 14) Check the 12 x 21 x 6 mm water seal lip for cut and replace if necessary. [1] 12 x 21 x 6 mm WATER SEAL 15) Remove the two 12 x 21 x 6 mm water seals from the shift rod holder using a commercially available oil seal remover. [2] SHIFT ROD HOLDER 16) Remove the 55.6 x 3.5 mm O-ring from the shift rod holder.
NOTICE Replace the 12 x 21 x 6 mm water seals with the new ones on assembly. Replace the 55.6 x 3.5 mm O-ring with a new one on assembly. [3] 55.6 x 3.5 mm O-RING 14-48