honda — Propellor/Gear Case/Extension Case/Oil Case

5) Install the shift rod by aligning the shift cam of the shift rod with the groove in the shift slider so that the cutout of the shift rod spline faces in the cruising direction. [1] CUTOUT [2] Mark in the shift rod end. Check for marking in the end of the shift rod. If the shift cam is in alignment with the groove in the shift slider but the cutout of the spline is not in the cruising direction, see the step 3 on page 14-44 and adjust accordingly. NOTICE [4] CRUISING DIRECTION [3] SHIFT ROD [3] SHIFT ROD [5] CAM [6] GROOVE IN SHIFT SLIDER 6) Apply grease to the circumference of the new 55.6 x 3.5 mm O-ring and install it on the shift rod holder.

[2] SHIFT ROD HOLDR [1] 55.6 x 3.5 mm O-RING 7) Install the shift rod holder aligning the projection with the concave in the gear case and tighten it with the pivot washer and the 6 x 12 mm hex. bolt. After installation, check that the cutout of the shift rod spline faces in the cruising direction. [1] SHIFT ROD HOLDER [2] PROJECTION [3] 6 x 12 mm HEX. BOLT [4] PIVOT WASHER [5] CONCAVE 14-52 [1] [2] NO MARK [3] SHIFT ROD [4] [5] MARK [3] SHIFT ROD