17) Install the woodruff key in the groove in the vertical shaft. Align the groove in the pump impeller with the woodruff key and install the impeller housing by turning it clockwise. [2] WOODRUFF KEY Turn the impeller housing clockwise when it is turned with the pump impeller mounted. After installing the impeller housing, check that the impeller gasket is set in the proper position. NOTICE [1] VERTICAL SHAFT [3] GROOVE IN PUMP IMPELLER [4] IMPELLER HOUSING [5] GROOVE 18) Improve the four distance collars on the impeller housing, and tighten the four 8 mm washers and the four 8 x 40 mm hex. bolts to the specified torque. TORQUE: 19.7 N . m (2.0 kgf . m, 14 lbf .
ft) [2] WATER TUBE SEAL RING [1] SPEED SENSOR TUBE C ASSEMBLY (5 x 270 mm TUBE) 19) Apply grease to the inner wall of the water tube seal ring. Install the water tube seal ring aligning the projection with the hole in the housing. [3] 8 x 40 mm HEX. BOLT (4) 20) Install the speed sensor tube C assembly (5 x 270 mm tube). [4] 8 mm WASHER (4) 21) Install the following parts. – Gear case assembly (P. 14-44) – Propeller (P. 14-2) [5] DISTANCE COLLAR (4) [6] IMPELLER HOUSING 14-55