6) Hold the vertical shaft upright (with the pinion gear toward up) and secure the vertical shaft. [1] DEPTH GAUGE (Commercially available) 7) Set the commercially available depth gauge at the gauge adapter of the pinion gear side as shown. Measure the vertical shaft length (distance D) and record it. [2] PINION GEAR [3] GAUGE ADAPTER, 110 mm 070PJ-ZY30100 8) Assemble the outer race and the inner race of the 30 x 62 x 40 mm taper roller bearing, and turn the outer race two or three turns. [1] OUTER RACE 9) Measure the bearing height from the outer race end to the inner race end as shown, and record the measurement.
[2] INNER RACE 10) Measure the height of the taper roller bearing outer race and record it. [1] OUTER RACE 14-78