c. THRUST CLEARANCE ADJUSTMENT Adjust the thrust clearance after replacement of the forward bevel gear shim. [1] DIAL INDICATOR 1) Check that the bearing holder assembly is securely tightened to the specified torque on the propeller shaft holder (P. 14-65). Check that the clutch shifter and the shift slider are not installed (P. 14-57). [2] PROPELLER SHAFT HOLDER ASSEMBLY 2) Fix the propeller shaft holder assembly on the fixing tool securely using the bolt as shown (P. 14-59). 3) Set the dial indicator perpendicularly so that its tip contacts the end of the propeller shaft. 4) Move the propeller shaft up and down and read the runout of the dial indicator.
It must be within the specified range. 5) If the thrust clearance exceeds the specification, increase the thrust shim thickness and recheck the thrust clearance. If the thrust clearance is less than the specification, reduce the thrust shim thickness and recheck the thrust clearance. [3] FIXING TOOL 14-87 Standard value 0.2 – 0.4 mm (0.01 – 0.02 in)